This is an old revision of the document!
BQ Witbox (1)
Manual
Pre-Print Checks
- Is the printbed level?
- If not –> Printbed Leveling
- Is the surface clean?
- If not –> Clean with alcohol/spirit/glass cleaner
- Is the filament dustfree? If not –> Clean with pressured air.
- Make sure dust does NOT get into the extruder.
- Print and deploy a Filament Cleaner if not present
- Is the filmanet entangled? –> disentangle.
- Load correct material profile in Cura.
- If in doubt use “Fast” –> see Materials
- Are you printing Nylon?
- Prep with Glue Stick. Clean/Remove with Water afterwards.
- Need to change filament?
- Check for difference in extrusion temperature and follow guide
monthly Maintenance
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft