Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
3dprinting:witbox [2019-04-29 05:35] xro created |
3dprinting:witbox [2019-04-29 05:45] (current) xro |
||
---|---|---|---|
Line 9: | Line 9: | ||
<WRAP center round help 60%> | <WRAP center round help 60%> | ||
+ | - Is the removable printbed latched in? | ||
+ | * if not -> move until it's level and all magnets are connected | ||
- Is the printbed level? | - Is the printbed level? | ||
- | * If not –> [[#printbed_leveling|Printbed Leveling]] | + | * If not –> Select Leveling from Display-Menu, follow instructions and use the three screws below printbed to level. |
- | - Is the surface clean? | + | - Is the blue-tape on the surface ok? |
- | * If not –> Clean with alcohol/spirit/glass cleaner | + | * If not –> remove tape-strip that is broken and replace with a new strip. Blue-tape can be found and belongs in in the filament box. |
- | - Is the filament dustfree? If not –> Clean with pressured air. | + | - Is the filament dustfree? If not –> Clean with cloth or pressured air. |
* Make sure dust does NOT get into the extruder. | * Make sure dust does NOT get into the extruder. | ||
* Print and deploy a [[https://www.thingiverse.com/search?q=filament+cleaner|Filament Cleaner]] if not present | * Print and deploy a [[https://www.thingiverse.com/search?q=filament+cleaner|Filament Cleaner]] if not present | ||
- Is the filmanet entangled? –> disentangle. | - Is the filmanet entangled? –> disentangle. | ||
- Load correct material profile in Cura. | - Load correct material profile in Cura. | ||
- | * If in doubt use "Fast" –> see [[#materials|Materials]] | + | * If in doubt use "Low definition" since it's fast –> see [[materials|Materials]] |
- | - Are you printing Nylon? | + | |
- | * Prep with Glue Stick. Clean/Remove with Water afterwards. | + | |
- | - Need to change filament? | + | |
- | * Check for difference in extrusion temperature and [[#changing_filaments|follow guide]] | + | |
</WRAP> | </WRAP> | ||
+ | |||
====== monthly Maintenance ====== | ====== monthly Maintenance ====== | ||
+ | |||
+ | TODO | ||
+ | |||
+ | ====== supported Materials ====== | ||
+ | |||
+ | * PLA 1.75mm | ||
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft