Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
3dprinting:materials [2019-10-17 17:42]
xro
3dprinting:materials [2019-10-17 17:51]
xro
Line 67: Line 67:
       * needs raft for less than 4cm² ground surface       * needs raft for less than 4cm² ground surface
   * PLA 1.75 (for Witbox)   * PLA 1.75 (for Witbox)
 +      * //normal price//
       * Colors in r3: blue, .....       * Colors in r3: blue, .....
       * Extrusion-temp:​ 220°C       * Extrusion-temp:​ 220°C
 +  * ABS
 +      * //normal price//
  
 See the [[https://​www.lulzbot.com/​sites/​default/​files/​v2/​LulzBot_3D_Printing_Filament_Guide.pdf|Lulzbot Filament Guide]] on print-settings for various materials. See the [[https://​www.lulzbot.com/​sites/​default/​files/​v2/​LulzBot_3D_Printing_Filament_Guide.pdf|Lulzbot Filament Guide]] on print-settings for various materials.
Line 77: Line 80:
  
   * Cost is per meter filament (2.85..3mm ø)   * Cost is per meter filament (2.85..3mm ø)
-  * Cura (or slicer of your choice) tells you how many meters you will need+  ​* Experimental:​ Cost per g (As we have different filaments widths, this is an attempt at simplification) 
 +    * if g and m cost disagree, choose cost per m or the average between the two at your discretion 
 +    * calculated for NGEN. Probably not as applicable for other materials yet. 
 +  ​* Cura (or slicer of your choice) tells you how many meters ​and g you will need
   * We pay per started meter. e.g. you upround   * We pay per started meter. e.g. you upround
   * Please feed the cat next to the printer with the € before printing   * Please feed the cat next to the printer with the € before printing
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft
  • /var/lib/dokuwiki/data/pages/3dprinting/materials.txt
  • Last modified: 2019-10-17 17:51
  • by xro