Do not exceed maximums

Second, the electronic load on the initial state of power:

The electronic load automatically saves the switching state before shutting down and acts as the initial state of the next power-on;

Third, discharge capacity and discharge time statistics:

  Discharge capacity Statistics: the load current is not zero start statistics, until the next load current is zero, it is believed that the completion of a discharge process, statistical end;
  Discharge time Statistics: from the current is not zero start statistics, to the next load current is zero, think that the completion of a test process, statistical end; 

Four, set the maximum capacity (OAH) and set the maximum discharge time (OHP):

  Set maximum Capacity (OAH): When the OAH function is started, when the load discharge capacity is higher than the maximum capacity set, the electronic load stops automatically and flashes to display "OAH", and when the OAH alarm is lifted, the capacity statistics are automatically emptied;
  Set the maximum discharge time (OHP): When the OHP function is started, when the load running time is greater than the maximum discharge time set, the electronic load stops automatically and flashes to display "OHP", and when OHP alarm is lifted, the time statistics are automatically emptied; 

Note: In the absence of the OAP and OHP function, the electronic load will record the discharge capacity and discharge time, turn on the OAH and OHP function, to the set value after the electronic load stopped working; When the OHP function is turned on, the running time of the electronic load is the countdown mode;

OAP and OHP functions, can be a good implementation of unattended power aging testing.

Five, Data group Features:

Divided into “DAT0”, “DAT1”

DAT0: Flashing shows only the capacity value and running time of the previous stage, and does not add up to the next stage;

DAT1: Flashing shows the capacity value and running time of the previous stage, and automatically adds up to the next stage;

Connect your PC via USB port above FZ35. Use serial console with 9600 8 N 1

No alarm status:

Load supply voltage, load current, capacity value, discharge time;

11.90V,0.11A,0.004Ah,00:02 à Load voltage 11.90V, load current 0.11A, capacity 0.004Ah, discharge time 00:02;

Note: If the maximum discharge time is turned on, 00:02 indicates a countdown;

Upload Alarm status code (OVP/OCP/OPP/LVP/OAH/OHP/OTP)

OVP:25.2, OCP:5.10, OPP:35.5, LVP:1.50,OAH:0222,OHP:00:00,

Overvoltage, overcurrent, over power, undervoltage, maximum capacity, maximum discharge time

Software Version: 2.09

Hardware Version: ….