Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
3dprinting:lulzbot [2019-03-25 17:32] xro [Materials] |
3dprinting:lulzbot [2019-11-08 19:48] xro |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| - Is the filmanet entangled? –> disentangle. | - Is the filmanet entangled? –> disentangle. | ||
| - Load correct material profile in Cura. | - Load correct material profile in Cura. | ||
| - | * If in doubt use "Fast" –> see [[#materials|Materials]] | + | * If in doubt use "Fast" –> see [[materials|Materials]] |
| - Are you printing Nylon? | - Are you printing Nylon? | ||
| * Prep with Glue Stick. Clean/Remove with Water afterwards. | * Prep with Glue Stick. Clean/Remove with Water afterwards. | ||
| Line 207: | Line 207: | ||
| ^currently mounted Nozzle^| | ^currently mounted Nozzle^| | ||
| - | |Diameter|0.35mm| | + | |Diameter|0.5mm| |
| |Max Temperature|240°C (exceed at risk of **DAMAGE**)| | |Max Temperature|240°C (exceed at risk of **DAMAGE**)| | ||
| |Type|Budaschnozzle 2.0c| | |Type|Budaschnozzle 2.0c| | ||
| + | |||
| + | ===== Known Problems ===== | ||
| + | |||
| + | * Metal Platform holding print-bed is bent at all corners | ||
| + | * this makes leveling harder, as the bending angle is different in all four corners | ||
| + | * this means that the Z-offset (screw below Z-Endstop on controller-side) needs to be set lower that it originally was | ||
| + | * this means, when z-leveling, the extruder-header goes lower than it was designed for and sometimes makes hurtful noises | ||
| + | * Folien gehört getauscht | ||
| + | * muss aufgeheizt werden auf 60°C bevor neue Folien aufgeklebt wird, sonst bilden sich blasen | ||
| ===== Current Firmware Settings ===== | ===== Current Firmware Settings ===== | ||
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft