Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
3dprinting:lulzbot [2019-03-25 17:32] xro [Materials] |
3dprinting:lulzbot [2019-11-07 22:45] xro |
||
---|---|---|---|
Line 20: | Line 20: | ||
- Is the filmanet entangled? –> disentangle. | - Is the filmanet entangled? –> disentangle. | ||
- Load correct material profile in Cura. | - Load correct material profile in Cura. | ||
- | * If in doubt use "Fast" –> see [[#materials|Materials]] | + | * If in doubt use "Fast" –> see [[materials|Materials]] |
- Are you printing Nylon? | - Are you printing Nylon? | ||
* Prep with Glue Stick. Clean/Remove with Water afterwards. | * Prep with Glue Stick. Clean/Remove with Water afterwards. | ||
Line 207: | Line 207: | ||
^currently mounted Nozzle^| | ^currently mounted Nozzle^| | ||
- | |Diameter|0.35mm| | + | |Diameter|0.5mm| |
|Max Temperature|240°C (exceed at risk of **DAMAGE**)| | |Max Temperature|240°C (exceed at risk of **DAMAGE**)| | ||
|Type|Budaschnozzle 2.0c| | |Type|Budaschnozzle 2.0c| |
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft