Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
3dprinting:lulzbot [2019-03-25 17:21] xro [Materials] |
3dprinting:lulzbot [2019-04-29 05:45] xro |
||
---|---|---|---|
Line 20: | Line 20: | ||
- Is the filmanet entangled? –> disentangle. | - Is the filmanet entangled? –> disentangle. | ||
- Load correct material profile in Cura. | - Load correct material profile in Cura. | ||
- | * If in doubt use "Fast" –> see [[#materials|Materials]] | + | * If in doubt use "Fast" –> see [[materials|Materials]] |
- Are you printing Nylon? | - Are you printing Nylon? | ||
* Prep with Glue Stick. Clean/Remove with Water afterwards. | * Prep with Glue Stick. Clean/Remove with Water afterwards. | ||
Line 133: | Line 133: | ||
====== Materials ====== | ====== Materials ====== | ||
- | <WRAP center round tip 60%> ** Correct profiles for each material can be found in: ** ''~/lulzbot/cura profiles for TAZ4/'' | + | <WRAP center round tip 60%> ** Correct profiles for each material can be found in: ** ''~/lulzbot/cura profiles for TAZ4/'' on Würfel or [[https://github.com/realraum/3dprinting | on Github]] |
**Fast Profile** is alsmost always the right choice, unless you intend to print small models with very fine structures. | **Fast Profile** is alsmost always the right choice, unless you intend to print small models with very fine structures. |
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft