Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
3dprinting:anycubic [2020-07-26 03:16] peter.poetzi |
3dprinting:anycubic [2020-07-26 13:51] peter.poetzi |
||
---|---|---|---|
Line 19: | Line 19: | ||
* ABS bitte nur auf 3M blue tape mit UHU Stick drucken | * ABS bitte nur auf 3M blue tape mit UHU Stick drucken | ||
* PETG auf blue tape aber ohne UHU Stick drucken. Auf keinen Fall direkt auf die Platte (geht nicht mehr ab). | * PETG auf blue tape aber ohne UHU Stick drucken. Auf keinen Fall direkt auf die Platte (geht nicht mehr ab). | ||
+ | * Das extrudr greentec pro lässt sich wohl nicht direkt auf der platte drucken (geht während dem Druck wieder ab), eventuell mit blue tape und UHU Stick probieren | ||
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft