This is an old revision of the document!
Anycubic i3 mega
3D Drucker, Dauerleihgabe von peterpoetzi
Bauvolumen: 210x210x205 mm 0.4mm Düse Filament: 1.75mm, ABS und PLA
Slicen kann man in cura, hier einfach neuen Drucker hinzufügen und Anycubic i3 mega auswählen. Funktioniert.
Empfohlene Einstellungen: ABS: Extruder 245°C, Heatbed 85°C, mit Styroporgehäuse drucken
PLA: Extruder 200°C, Heatbed 60°C, auf jeden Fall OHNE Styroporgehäuse drucken
- PLA kann direkt ohne Kleber auf die Platte gedruckt werden. Wenn die Platte abgekühlt ist, gibt sie auch das Bauteil wieder her
- ABS bitte nur auf 3M blue tape mit UHU Stick drucken
- PETG auf blue tape aber ohne UHU Stick drucken. Auf keinen Fall direkt auf die Platte (geht nicht mehr ab).
Es ist ein Raspberry Pi 3B+ mit octoprint vorhanden, derzeit unter http://192.168.127.167 erreichbar. Einfach gcode hochladen und Drucken. Auch eine Webcam ist angesteckt. Username: r3 Passwort: wie wlan passwort
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft