Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
3dprinting:lulzbot [2019-03-25 17:32] xro [Materials] |
3dprinting:lulzbot [2019-04-29 05:45] xro |
||
|---|---|---|---|
| Line 20: | Line 20: | ||
| - Is the filmanet entangled? –> disentangle. | - Is the filmanet entangled? –> disentangle. | ||
| - Load correct material profile in Cura. | - Load correct material profile in Cura. | ||
| - | * If in doubt use "Fast" –> see [[#materials|Materials]] | + | * If in doubt use "Fast" –> see [[materials|Materials]] |
| - Are you printing Nylon? | - Are you printing Nylon? | ||
| * Prep with Glue Stick. Clean/Remove with Water afterwards. | * Prep with Glue Stick. Clean/Remove with Water afterwards. | ||
realraum Graz, Brockmanngasse 15, 8010 Graz, realraum - Verein für Technik in Kultur und Gesellschaft